1.The lifting of the table is drived by the oil pump
2.The tenderlenburg,lateral tilt left/right,backplate upward/downward,head rest is controlled by air cylinder
3.The shell of the base is stainless steel
4.The mattress are made of PU material.It is soft and comfortable.with plasticity against pressure ulcers effectively

ITEM	CONTENTS
Table height(mm)	710mm～910mm
Length and width of table	1950mm*480mm
Reversed Trendelenburg of table	20º
Trendelenburg of table	25º
Left inclining angle of table	15º
Right inclining angle of table	15º
Upward folding angle of back rest	75º
Downward folding angle of back rest	40º
Upward folding angle of head rest	50º
Downward folding angle of head rest	50º
Downward folding angle of leg rest	90º
Lifting height of waist bridge	80mm

Standard Accessories	PAX-ST-A
Leg rest	2pcs
Body support holder	2pcs
Arm rest	2pcs
Anesthetic screen holder	1pcs

• Before operating, be sure that operating, be sure that the operating table has been correctly installed as the description in chapter 11
• The max load weight of legrest is 30 kg and of headrest is 10 kg.

Symbol Notes

Insert the plug into the socket and switch the main power. Now the equipment is ready to work.

No.	Operating	Method
1	Lock the operating table	Keep "E" pushed and press "operating locked"
2	Move the operating table	Keep "E" pushed and press "operating unlocked"
3	Raise the operating table	Keep "E" pushed and press "table upwards"
4	Lower the operating table	Keep "E" pushed and press "table downwards"
5	Backrest up inclination	Keep "E" pushed and press "Backrest up inclination"
6	Backrest down inclination	Keep "E" pushed and press "Backrest down inclination" Note: Be carefull about the angle
7	Table left tilt	Keep "E" pushed and press "Table left tilt"
8	Table right tilt	Keep "E" pushed and press "Table right tilt"
9	Table up inclination	Keep "E" pushed and press "Table up inclination"
10	Table down inclination	Keep "E" pushed and press "Table down inclination"
11	Headrest up inclination
12	Headrest down inclination	Support the headrest and pull the shaft out aof the ratchet wheel.
13
14		Loose the triangular switch for the headrest and pull the headrest out.
15		Pull the loop out and pull the largest up slightly to apart from the ratchet wheel, then the largest angle can be adjusted; Release the loop for locking a desired angle.
16		Loose the triangular switch for legrest by 2 or 3 times circles to apart the legrest from the gear wheels; Tilt the legrest outside to reach a desired angle and tight the switch clockwise.
17	Disassemble the legrest	Loose the triangular switch for legrest anticlockwise to apart the legrest from the corse shaft. Assemble it in the reverse.